Dynomotion

Group: DynoMotion Message: 12726 From: Santiago Date: 1/20/2016
Subject: Re: Digest Number 1901
DynoMotion
Hy Tom, thanks for the fast replay,  I conect the five sensors in serial and in normaly close, all of them goes to IOS17, I´m running Kmotion 433
regards
 
 
 
 
 
 
 
Sent: Wednesday, January 20, 2016 10:28 AM
Subject: [DynoMotion] Digest Number 1901
 

2 Messages

Digest #1901

Messages

Tue Jan 19, 2016 3:37 am (PST) . Posted by:

"Santiago" siegc4

Hallo , I conect the limit swith to the mill, and they work fine, once they reach,Kflop stops the table, the problem is to move it after that.
In mach 3 when the table reach the limit , an error ocurs and everything stops, then you restart and while limit is presed you can move the table to the other side.
But in Kmotion CNC I do not see the way to do it. I restart and when I try to move it , it stops again

---
El software de antivirus Avast ha analizado este correo electrónico en busca de virus.
https://www.avast.com/antivirus

Tue Jan 19, 2016 9:19 am (PST) . Posted by:

"Tom Kerekes" TKSOFT

Hi,

What Limit Switch Mode are you selecting?

Do you have separate inputs for each end of travel?

What Version of KMotion are you running?

Regards
TK

On 1/19/2016 3:38 AM, 'Santiago' siegc4@... [DynoMotion] wrote:
>
> Hallo , I conect the limit
swith to the mill, and they work fine, once
> they reach,Kflop stops the
table, the problem is to move it after that.
> In mach 3 when the table
reach the limit , an error ocurs and
> everything stops, then you restart
and while limit is presed you can
> move the table to the other
side.
> But in Kmotion CNC I do not see the way to do it. I restart and
when
> I try to move it , it stops again
>
<https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=emailclient>
> Este correo electrónico se ha enviado desde un equipo libre de virus
> y protegido por Avast.
> www.avast.com
>
<https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=emailclient>
>
>
>

Este correo electrónico se ha enviado desde un equipo libre de virus y protegido por Avast.
www.avast.com
  @@attachment@@
Group: DynoMotion Message: 12727 From: Tom Kerekes Date: 1/20/2016
Subject: Re: Digest Number 1901 [1 Attachment]
Hi Santiago,

With only one input for everything it isn't possible to tell which axis is in the limit and what direction it is safe to move.

You might add a User Button to disable limit switch configuration for a few seconds to allow you to move back out.  Or add a hardware override switch.

Regards
TK

On 1/20/2016 1:15 PM, 'Santiago' siegc4@... [DynoMotion] wrote:
[Attachment(s) from Santiago included below]

Hy Tom, thanks for the fast replay,  I conect the five sensors in serial and in normaly close, all of them goes to IOS17, I´m running Kmotion 433
regards